www.ejtag.ru

Точки ISP (из интернет):

Окно программы:

Фото подключения к плате:

Логи программатора:

Enumerated as HS is 21
USB VCC: Chip VCC = 3,31
LibUSB ver 1.2.6.0
FileVersion = 0.2.21.37
Using:
1bit bus
EMMC timing (8MHz)
Use Fixed Block operation
Using Ignore Errors
eMMC OCR 0xC0FF8080 after 2 attempts
Send CMD1 error!
eMMC (0) CID = 110100303034473930104BCDA28851 (33)
Send CMD2 error!
Found 1 eMMC device(s)
eMMC CSD = D00E00320F5903FFFFFFFFE7924000
eMMC Status: 00000700
CURRENT_STATE = Stby
eMMC: Version 4.xx
eMMC: Maximum speed 26,00 MHz
eMMC: Read Block Length 512 byte
eMMC: Write Block Length 512 byte
eMMC: Card High Capacity
eMMC: CSD User Partition Size = 1073741824 Byte
eMMC: WP Status True
eMMC: WP Size 8 erase groups
eMMC: Permanent WP is False
eMMC: Temorary WP is False
Valid mode SDR 1 bit
eMMC: EXT_CSD:
000000000000000101013F3F00000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000053200000000001E00
225522880A50000155020A0700100808
0210010609001000007600000014640F
3C0F1E0000002222010A0F1700020006
00000000000000000000000000000000
00000000000000041F05000000000003
0001D800000000000000000000000000
00000000000000000000000000010000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
0100000A000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
00000000000000000000000000000000
eMMC: DRIVER_STRENGTH F
SET: Using Mode1 strength
EXTCSD: Device support 4K sector
EXTCSD: Current sector size 512 byte
EXTCSD: Device support HS SDR 26MHz
EXTCSD: Device support HS SDR 52MHz
EXTCSD: Device support HS DDR 52MHz 1.8V
EXTCSD: Device support HS200 SDR 1.8V
EXTCSD: EXT_CSD RST_n временно отключен
EXTCSD: ACC Size = 65536 byte
eMMC: EXT_CSD User Partition Size = 3959422976 Byte
eMMC: Version 4.5
EXTCSD: FW CONFIG = 0x0
EXTCSD: PARTITION CONFIG = 0x0
EXTCSD: BOOT BUS WIDTH = 0x0
Загрузка с еММС не используется
x1 (sdr) или x4 (ddr) используется при загрузке
EXTCSD: Device support partitioning features
EXTCSD: Device support enhanced technological features
eMMC: Erase Group Size = 512 KByte (1024 blocks)
eMMC: Boot partition size 2097152 byte
eMMC: RPMB partition size 524288 byte
RPMB: Authentication key not yet programmed
eMMC MID = 0x0011, OEM ID = 0x0001
eMMC Product Name = 004G90
eMMC Name = THGBM5G5A1JBAIR
eMMC Serial number = 0x4BCDA288
eMMC Revision = 1.0
eMMC Date 5/1998


Используем все разделы eMMC
Читаем раздел User в файл D:\ENTT\emmc_tt_v3_0.2.21.37\Dumps\1.user
Чтение начато
10:51:18
READ: читаем по 1024 блоков
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 35840 (0%)
Send CMD7 error!
Ошибка чтения блока 35840, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 35840 (0%)
Send CMD7 error!
Ошибка чтения блока 35840, попытка 2
Read Single Block: FIFO Timeout (Status 0x8C0A8F, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8C0A8F, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8C0A8F, not readed 512)
Ошибка чтения блока 35840 (0%)
Send CMD7 error!
Ошибка чтения: считано 648 блоков из 1024
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x4000005, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 36864 (0%)
Send CMD7 error!
Ошибка чтения блока 36864, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 36864 (0%)
Send CMD7 error!
Ошибка чтения блока 36864, попытка 2
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8A0A90, not readed 512)
Ошибка чтения блока 36864 (0%)
Send CMD7 error!
Ошибка чтения: считано 67 блоков из 1024
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 37888 (0%)
Send CMD7 error!
Ошибка чтения блока 37888, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 37888 (0%)
Send CMD7 error!
Ошибка чтения блока 37888, попытка 2
Read Single Block: FIFO Timeout (Status 0x880A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x880A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x880A90, not readed 512)
Ошибка чтения блока 37888 (0%)
Send CMD7 error!
Ошибка чтения: считано 20 блоков из 1024
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 38912 (0%)
Send CMD7 error!
Ошибка чтения блока 38912, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 38912 (0%)
Send CMD7 error!
Ошибка чтения блока 38912, попытка 2
Read Single Block: FIFO Timeout (Status 0x8F0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8F0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8F0A90, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8F0A90, not readed 512)
Ошибка чтения блока 38912 (0%)
Send CMD7 error!
Ошибка чтения: считано 24 блоков из 1024
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 39936 (0%)
Send CMD7 error!
Ошибка чтения блока 39936, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 39936 (0%)
Send CMD7 error!
Ошибка чтения блока 39936, попытка 2
Read Single Block: FIFO Timeout (Status 0x8D0A91, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8D0A91, not readed 512)
Read Single Block: FIFO Timeout (Status 0x8D0A91, not readed 512)
Ошибка чтения блока 39936 (0%)
Send CMD7 error!
Ошибка чтения: считано 68 блоков из 1024
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Ошибка чтения блока 54272 (0%)
Send CMD7 error!
Ошибка чтения блока 54272, попытка 1
USB: Fast read data block, readed -116 byte
USB: Fast read data block, readed -116 byte
USB: Error fast read data block, readed only 0 byte
Read Single Blocks: Data DMA Error (Status 0x600001D, DMA 0x0)
Read Multi Block: Error read block_data!
Считано 28311552 байт
Прервано!
Чтение завершено
10:53:48